Mixer-probe for installation in mixers applications. Conceived for use in rough environments. Additional protection against abrasion through 8mm thick hardened or unhardened replaceable tubing. The sensor surface is protected by means of a 10mm strong ceramic outer cover. Fixed with a massive, weldable mounting ring with bolts on the sides for inserting and adjustably positioning the protected mixer probe.
Product Infos
Appilications for the mixer probe FSM
- moisture and homogeneity of the "dry mix"
- moisture and homogeneity of the "wet mix"
- when the mix is homogeneous
- water batching behaviour (continuous or complete water addition)
Mounting instructions for the mixer probe FSM
- The probe must be positioned in such a way that always some material is present on or in front of the measuring surface of the sensor while the mixer is in motion.
- For pan type mixers it is recommended to mount the probe on the mixing tray. For horizontal mixers the probe should be mounted on the front wall of the container.
- Possible peaks in the signal due to the mixer arm can be eliminated by limit setting and average building functions of the evaluating electronics.
Technical data
| Connection to the probe | Connecting cable: 5 x 0.22 mm2 shielded Cable is assembled with metallic terminal sleeves. Plug is optional. |
| Probe supply | FSM30 = 10 V-30 V DC FSM = +/-15 V (Tolerance each +/-0,5 V) |
| Current input | 30 mA (at +15 V for voltage output of 0-10 V) 30 mA (at –15 V for voltage output of 0-10 V) 50 mA (at +15 V for current output 0-20 mA) 30 mA (at –15 V for current output 0-20 mA) 10-30 V Probes: 9V-30V DC Current input: 190 mA for 10 V Supply 120 mA for 15 V Supply 80 mA for 24 V Supply 70 mA for 30 V Supply |
| Signal output | Standard: 0-10 V Output load resistance: 100 kohm Option: 0-20 mA or 4-20 mA Load resistance: 500 Ohm 0.1%, TK = 25 ppm |
Downloads
